Drag the measurement window to the desired location and size.Enter the IP address in the window that opens (port should already be filled) and click “Connect”.In Resolve, switch to the “Color” tab and then choose “Monitor calibration”, “CalMAN” in the “Color” menu (Resolve version 11 and earlier) or the “Workspace” menu (Resolve 12).A message “Waiting for connection on IP:PORT” should appear.If desired, adjust the 3D LUT output format and encoding.A blend between input offset (BT.1886) and output offset can be achieved by setting tone curve to “Custom” and output offset between 0% and 100%. to target a gamma 2.2 “output offset” (pure power) curve, set tone curve to “Gamma 2.2”. If you want to target a different tone curve for the 3D LUT, go to the “3D LUT” tab and adjust the options as desired.Note that this setting does not influence the 3D LUT tone curve, which you can adjust in the next step. If you do want to use iterative gray balance calibration, set calibration tone curve on the “Calibration” tab from “As measured” to “Rec. The “Resolve” preset is set up to not use iterative gray balance calibration, as normally it shouldn’t be needed.If the display is well-behaved, the effect may be negligible. If you need to save time, you may reduce the amount of measured patches at the cost of accuracy. More patches increase measurement and profile processing time as well as characterization accuracy. The default 1553 patches should already give good results.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |